DIY boards

What you will need:

-5 thick A3 (42×29.7) sheets of paper or cardboards, preferably of different colors.

-a pair of scissors

-a black marker

-a ruler

Step 1: Print the doors

Before starting the boards, download this PDF document. As for normal cards, print the page, glue it to a thick paper sheet and cut the cards. These will be used to indicate the doors, locked doors or stairs on your board.

Step 2: Make the boards

Follow the instructions below to cut your A3 sheets.

Page 1:

Shove off a little bit of the bottom of the page, so that it is 42×28.

On 1 side, use the marker to draw lines all around and a line in the middle.

On the other side, draw lines all around and lines as shown below.

Page 2:

Shove off a little bit of the bottom of the page, so that it is 42×28. Then, cut a large square 28×28.

On 1 side, use the marker to draw lines all around.

On the other side, draw lines all around and lines as shown below.

Page 3:

Shove off a little bit of the bottom of the page, so that it is 42×28. Then, cut a large square 28×28.

On one side, draw lines all around and lines as shown below.

On the other side, draw lines all around and lines as shown below.

Page 4:

Shove off a little bit of the bottom of the page, so that it is 42×28. Cut a large square 28×28, then cut this square in four smaller squares (14×14).

On one side, draw lines all around.

On the other side, draw lines all around. Draw a line in the middle of the longer piece as shown below.

Page 5:

Shove off a little bit of the bottom of the page, so that it is 42×28.

Cut three long pieces, then cut one of them in half. Draw lines all around.

On the other side, draw lines all around and lines as shown below.

Step 3: Play

The board pieces can be used with any of our RPG or Puzzle adventures. But you can also use them to create your own dungeons and adventures! Connect them using the doors and stairs, invent your stories and play.

%d bloggers like this: